![]() ![]() In addition to China, paper was also imported from India or Japan. ![]() Chine-colléĬhine is the French word for China, referring to the fact that the thin paper originally used with this technique was imported from China. The printmaker then uses a scraper and burnisher to even out some of the pits to create soft and subtle contrasting layers. Therefore mezzotint means “middletone.” The printmaker repeatedly rocks the toothed edge of a curved blade (rocker) into the matrix to create a dense concentration of small pits. “Mezzo” means half, and “tint” means tone. It goes without saying that in order to master aquatint, the printmaker must have experimented with many different acid concentrations and corrosion times in order to have a good understanding of their effects. Areas covered with less material will be printed in a darker printed color, whereas areas covered with more material will be printed in a lighter colour. The printmaker first spray paints the matrix with an anti-corrosive material such as resin, before putting it into acid baths of different intensities which will corrode the uncovered parts, and leave the layout with colour blocks of different sizes and shapes. AquatintĪquatint, also known as fine-point etching, can create rich tonal effects. After cleaning and inking the matrix, the corroded parts will hold ink, which will transfer onto the pre-wetted paper when pressure is applied from the printing press. The scraped-off parts will be corroded by acid when the matrix is put into the acid bath. This ground is then scraped off by the printmaker using a needle-like tool to create the design. The printmaker first polishes the matrix before adding a layer of waxy material (ground). EtchingĮtching falls under the second type of intaglio technique, and is one of the most popular methods of printmaking. The rough edges of these lines are not removed before printing, and as a result, the ink penetrates into the rough edges and creates a soft and feathered line. This is where the printmaker uses a metal or diamond-tipped pen to carve directly on the matrix. Drypointĭrypoint is another intaglio printmaking technique that does not use chemicals to corrode the matrix. The printmaker then uses a three-faced steel knife (scraper) and rounded steel rod (burnisher) to polish the rough edges of the carved lines (burr). EngravingĮngraving falls under the first type of intaglio printmaking technique, where the printmaker uses a short steel rod (burin) to make thin lines on the matrix. There are two types of intaglio printmaking methods: the first is where designs are directly carved onto the matrix, and the second is where chemicals are used to corrode the design onto the matrix. Intaglio is a printmaking method where the printmaker carves out a design on the matrix, fills the carved space with ink, wipes away any remaining ink from the untouched part of the matrix, and covers the matrix with paper for pressing.
0 Comments
Leave a Reply. |